Electrical systems – 5000

Parameters & adjustments

Extended keypad - General

The truck can be programmed with a maximum of 10 operator profiles. The extended keypad then enables a maximum of 10 PIN codes to be assigned to each operator profile. This makes it possible to handle up to 100 different PIN codes.

NOTE!

If the extended keypad is activated, handling of standard PIN codes, that are normally accessible via parameter #10, is ignored.

Extended keypad - Programming

A group of PIN codes can be made accessible by defining them as a block. Block no. 0 is activated in the default setting. This means that 3 different operator profiles can be accessed from the very start. Activation of other blocks will make all the PIN codes for that block accessible (see Table 20:). If all 10 blocks have been activated, then 10 PIN codes will be accessible for the operator profile.

The truck software stores the standard PIN code set according to Table 20:

NOTE!

These PIN codes can be adjusted to any value, however, it is advisable to avoid identical PIN codes in different operator profiles.

Electrical systems – 5000

Parameters & adjustments

Starting programming using the extended keypad:

•Connect a suitable CAN-service key to X41.

•Enter code 341671 and depress on the keypad.

•Select a programming command from Table 19:

Table 19: Programming commands - extended keypad

Programming Function Notes

Reset to default settings

Depress “1” +

Depress “2” + B +

Depress “3” + B +

Depress “4” + B + F + NNNN +

The PIN codes in the block can be used

The PIN codes in the block cannot be used

Changing current PIN code

Blocks 1 - 9 are disabled. The original PIN codes are reset according to Table 20:

B = Block no. 0 - 9

B = Block no. 0 - 9

B = Block no. 0 - 9

F = Operator profile no. 0 - 9

NNNN = New PIN code

•Switch off the truck by pressing on the keypad.

Programming of the extended keypad is now complete.

Parameter #39 must be set to the value 5, 6, 7 or 8 in order for the new PIN codes to take effect.

Perform a test by logging in with one of the new PIN codes. It is important to verify that the correct operator profile is enabled when a specific PIN code is entered, especially if an operator profile has been programmed for a specific application or special goods handling.

Table 20: The table shows the standard PIN codes in the software. These can be activated for use or changed according to the preferences of the operator.

One or more of these blocks can be activated.

When logging in normally, an operator profile is activated when any of the PIN codes in an activated block is entered.

The truck software will deny log-in if PIN code “0000” is used.

Service technicians are requested to keep notes on activated blocks, PIN code changes and special operator profile settings.

NOTE!

If the extended keypad is reset, this does NOT affect the operator profile settings.