Electrical systems – 5000

10.4.5 TLS - Truck log system (optional)

General

The truck log system, which is CAN based, is either an integrated system (SD16) or a freestanding supplementary system (S16). A collision sensor can also be connected.

The TLS communicates wirelessly with a base station (RG3) once the truck is within range. The base station then receives information on what the truck has done since they last communicated with one another.

Registration

To register the truck with the base station, follow the instructions below:

•Position the truck close to the base station.

•Press and hold the green button for approx. 5-10 seconds until three LEDs on the base station start flashing at the same time. The base station can now communicate with the truck whenever it is within range.

Logging in/out SD16

Logging in and out is performed as usual via the keyboard on the handle (or by using an ID unit). The difference is that communication passes through the TLS, which makes all the decisions.

Logging in/out S16

Logging in and out is performed using the keyboard on the TLS.

Electrical systems – 5000

Functional description

Order numberDateValid from serial numberT-code 232370-0402006-04-10931876-787, 788

Collision sensor

If there is a collision sensor installed on the CAN bus, it registers when the truck bumps into something. If the impact exceeds a certain level, it is classified as a collision and the truck comes to a halt. It can be reset by entering the PIN code for “resetting the collision sensor” (see table below).

Settings

Additional equipment (software and wiring) from Davis Derby is required to change the TLS settings.

Table 12: Settings TLS

Function Description

PIN code PIN code for different driver profiles.

Default setting

00001 (profile 1)

00002 (profile 2)

00003 (profile 3)

11111 (resetting the collision sensor) Logoff