Inspection

b. Apply engine oil to entire outside area of rear oil seal. c. Press-fit the rear oil seal using a suitable drift (A) with outer diameter 115 mm (4.53 in) and inner diameter 90 mm (3.54 in).

•Press-fit to the specified dimensions as shown in the figure.

1 : Rear oil seal A : Cylinder block rear end surface

CAUTION: •Never touch the grease applied to the oil seal lip. •Be careful not to damage the rear oil seal mounting part of oil pan (upper) and cylinder block or the crankshaft. •Press-fit straight, checking that rear oil seal does not curl or tilt.

NOTE:

The standard surface of the dimension is the rear end surface of cylinder block. 3. Install in the reverse order of removal, for the rest of parts. Inspection

INSPECTION AFTER REMOVAL Clean oil strainer portion (part of the oil pump) if any object attached.

JPBIA4414ZZ

PBIC3952E

INFOID:0000000006337295