Inspection

Separation Work CAUTION: During the operation, secure support the engine by placing a piece of wood under the engine oil pan, transaxle oil pan and suspended the engine slinger by baby crane (movable hoist) etc.

29.Remove starter motor. 30.Separate engine and transaxle. 31.Lift with the hoist and separate the engine from the transaxle assembly. INSTALLATION Install in the reverse order of removal. •Do not allow oil to get on mounting insulator. Be careful not to damage mounting insulator. •When installation directions are specified, install parts according to the direction marks on them referring to components illustration. •Make sure that each mounting insulator is seated properly, and tighten mounting bolts and nuts. Inspection

INFOID:0000000006450010

INSPECTION AFTER INSTALLATION •Before starting engine check the levels of coolant, lubrications and working oils. If less than required quantity, fill to the specified level. •Before starting engine, bleed air from fuel piping. Refer to FL-50, "Air Bleeding" . •Run engine to check for unusual noise and vibration. •Warm up engine thoroughly to make sure there is no leakage of coolant, lubricants, working oil, fuel and exhaust gas. •Bleed air from passages in pipes and tubes of applicable lines.