2WD : Inspection

1. Install engine slinger to front cover front left side (A) and cylinder head rear right side (B).

: Engine front

Slinger bolts Front cover front left side: Cylinder head rear right side: : 32.9 N·m (3.4 kg-m, 24 ft-lb)

: 25.0 N·m (2.6 kg-m, 18 ft-lb)

JPBIA4422ZZ

2. Remove starter motor. Refer to STR-27, "MR16DDT : Exploded View" . 3. Lift with a hoist and separate the engine from the transaxle assembly. Refer to TM-84, "MR16DDT :

Exploded View" . INSTALLATION Note the following, and install in the reverse order of removal.

CAUTION: •Never allow engine oil to get on engine mounting insulator. Be careful not to damage engine mounting insulator. •Check that each mounting insulator is seated properly, and tighten mounting nuts and bolts. •When installation directions are specified, install parts according to the direction marks on them referring to the figure of components. Refer to EM-55, "2WD : Exploded View" .

Rear torque rod bracket 1. Temporarily tighten mounting bolts in the numerical order as shown in the figure.

: Vehicle front

2. Tighten mounting bolts to the specified torque in the numerical order as shown in the figure.

JPBIA4416ZZ

INFOID:0000000006709022

INSPECTION AFTER INSTALLATION

Inspection for Leakage The following are procedures for checking fluids leakage, lubricates leakage, and exhaust gases leakage. •Before starting engine, check oil/fluid levels including engine coolant and engine oil. If less than required quantity, fill to the specified level. Refer to MA-13, "Fluids and Lubricants" . •Use procedure below to check for fuel leakage. -Turn ignition switch “ON” (with engine stopped). With fuel pressure applied to fuel piping, check for fuel leakage at connection points. -Start engine. With engine speed increased, check again for fuel leakage at connection points. •Run engine to check for unusual noise and vibration. •Warm up engine thoroughly to check there is no leakage of fuel, exhaust gases, or any oil/fluids including engine oil and engine coolant. •Bleed air from lines and hoses of applicable lines, such as in cooling system. •After cooling down engine, again check oil/fluid levels including engine oil and engine coolant. Refill to the specified level, if necessary.

Summary of the inspection items: Items Before starting engine Engine running After engine stopped Engine coolant Level Leakage Level