Inspection

b. Apply a continuous bead of liquid gasket (A) with a tube presser (commercial service tool) as shown in the figure.

1 : Oil pan (lower) b : 7.5-9.5mm (0.295 - 0.374 in) c : φ 4.0 - 5.0 mm (0.157 - 0.197 in) : Engine outside

Use Genuine Liquid Gasket or equivalent. CAUTION: Attaching should be done within 5 minutes after liquid gasket application.

c. Tighten bolts in numerical order as shown in the figure.

NOTE:

•Tighten bolts the No.1 and No.2 in two steps. •The numerical order No.7 and No.11 shows the second steps.

2. Install oil pan drain plug. •Refer to the figure of components of former page for installation direction of drain plug washer. Refer to EM-99, "Exploded View" . 3. Install in the reverse order of removal after this step.

: Engine front

JPBIA4367ZZ

JPBIA4364GB

INFOID:0000000006337265

INSPECTION AFTER REMOVAL Clean oil strainer if any object attached. INSPECTION AFTER INSTALLATION 1. Check the engine oil level and adjust engine oil. Refer to LU-8, "Inspection" . 2. Start engine, and check there is no leakage of engine oil. 3. Stop engine and wait for 10 minutes. 4. Check the engine oil level again. Refer to LU-8, "Inspection" .