OPERATING INSTRUCTIONS

3.Do not use the starter motor for more than 10 seconds without stopping. Wait one minute between starts so the starter motor can cool.

4.If the engine stops when operating with a load, immediately start the engine again to prevent overheating caused by stopping the flow of oil for cooling and lubrication.

5.If the charge indicator comes on during operation, determine and correct the cause to avoid complete discharge of the battery and possible damage to other components of the electrical system. See your Dealer.

6.If the coolant temperature indicator comes on, remove the load and allow the engine to run at 1500 rpm until the indicator goes out. If the indicator does not go out within one minute, stop the engine and determine the cause.

Stopping The Engine

IMPORTANT: When stopping the engine after operating under heavy load, run the engine at 1500 RPM for a short period of time. This will allow the engine temperature to decrease gradually.

Step 1

Move the engine speed control lever to run engine at idle speed for three to five minutes to decrease the temperature of engine.

Step 3 Off Step 2

Turn the key switch to OFF position. Remove the key.

MID PTO LEVER

REAR PTO LEVER

Put the REAR PTO control lever, MID PTO control lever and the range shift lever in the OFF or N (neutral) position.

Cold Temperature Operation

To start and operate your tractor during cold ambient temperatures, use these procedures :

1.BATTERY – Mu st have a full charge.

2.FUEL —Must be clean and with no water. See fuel Specifications in this manual.

3.ENGINE OIL – Must have the correct visocity for the ambient temperature range.

4. TRANSMISSION HYDRAULIC FLUID – Use Hydraulic Transmission fluid.

5.COOLING SYSTEM – Must have ethylene glycol solution for protection.

6.TIRES – If there is liquid in the tires, the tires must have protection against temperatures below 0 o C (32 o F). See your Dealer.

7.STOPPING THE ENGINE – Run the engine at idle speed for a short period of time to permit the engine temperature to decrease before stopping.

8.CONDENSATION IN FUEL TANK – To prevent condensation in the fuel tank and water entering the fuel system, fill the fuel tank after each operating day.

9.FUEL FILTER CUP – During cold ambient temperatures, make sure you remove water from the fuel filter cup each day.

NOTE : Do not use ether as a cold temperature starting aid.

IMPORTANT: To start engine during cold ambient temperatures, put the engine control level at the low idle position. After starting the engine, run at 1500 rpm for approximately 5 minutes to warm the engine