OPERATING INSTRUCTIONS

Power Takeoff Guards

All tractors have a safety guard for the Rear PTO shaft and a safety cover for the Mid PTO shaft.

Rear Pto Guard Mid Pto Cover

Whenever a PTO driven machine is in operation, the PTO guard must be in place for most operations to prevent injury to the operator or bystanders. Where attachments, such as pumps, are installed on the PTO shaft (especially if the tractor PTO guard is moved upward or removed) extended shielding equivalent to the PTO guard must be installed with the attachment. Install the PTO guard to its original position immediately when the attachment is removed.

Pto Operating Safety

For the safe operation of the PTO, follow these safe operating procedures.

Three Point Hitch Connecting Implements

1.Connect the implement to the hitch. See THREE POINT HITCH SYSTEM in this manual.

2.Connect the implement driveline to the tractor.

3Check the driveline for correct length and for free telescopic movement by lifting and lowering hitch system. The correct length is important to prevent the driveline from hitting bottom or from separating in any tra ctor implement operating position.

Drawbar Connecting Implements

1.Connect the implement hitch to the drawbar with a hardened steel pin. Make sure the pin is securely held in place with a cotter pin or lock pin and does not make contact with the implement driveline.

2.Connect the implement hitch to the tractor drawbar before connecting the implement driveline to the PTO.

3.Connect the implement driveline to the tractor. Check the driveline for correct length and for free telescopic movement. The correct length is important to prevent the driveline from hitting bottom or from separating in any tractor or implement operating position.

PTO driven machinery can cause serious injury. Before working on or near the PTO shaft, or servicing or clearing the driven machine, put the PTO lever in the DISENGAGE position and STOP the engine.

When doing stationary PTO work and dismounting from the tractor with the PTO running, keep clear of all moving parts as they are a Potential safety hazard. M127

IMPORTANT: Follow the implement manufacturers recommendations in adjusting and aligning the implement and implement driveline with the tractor.

Drawbar

Your tractor is equipped with a drawbar. Use the drawbar for connecting all pull-behind implements.

DRAWBAR OPERATING POSITION

DRAWBAR HITCH CONNECTING PIN HOLE

STORAGE PIN HOLE WITHOUT MID PTO

IMPLEMENT CONNECTING PIN HOLE

The drawbar must be in the storage position when using the three-point hitch.

STORAGE POSITION (WITH MID PTO)

WITH MID PTO (OPTION)

STORAGE POSITION (WITHOUT MID PTO)

WITHOUT MID PTO

Try to balance the load primarily on the implement wheels - as in loading a trailer or spreader. Avoid overloading the drawbar. Add front end weights for improved stability. Engage the clutch smoothly, avoid jerking and use the brakes cautiously to avoid jackknifing.

Rear upset can result if pulling from wrong location on tractor. Hitch only to the drawbar. Use 3 point hitch only with the implements designed for its use - not as a drawbar