INSTRUMENTS /CONTROLS

5.CLUTCH PEDAL – The clutch must be disengaged when starting the engine, stopping the tractor, storing the tractor and operating the following levers,gear shift lever, range lever, rear PTO lever, MID PTO Lever, MFD lever creep lever.

5-1.DUAL CLUTCH

Pedal has three positions as follows:

1.Pedal completely released – Transmission and PTO engaged

2.Pedal partially released - Transmission disengaged, PTO engaged

3.Pedal completely depressed – Transmission and PTO disengaged

6.CLUTCH LOCK LATCH – For long term storage, lock the clutch pedal in the disengaged position. This will prevent the clutch disc from sticking to the engine flywheel.

Control Levers (Gear Drive)

1.GEAR SHIFT LEVER

— The gear shift lever is used to shift the transmission gears into reverse or any of the three forward speeds.

2.RANGE SHIFT LEVER — Move the range shift lever forward to place the transmission in L range. Move the lever to the rearward to place the transmission in M or H range. The center position between M and L or H and M places the transmission in N.

NOTE: Be sure the range shift lever is in N (Engine start) slot when starting the engine.

3. REAR PTO CONTROL LEVER – Move the lever forward to engage the REAR PTO. Move the lever rearward to disengage the Rear PTO.

NOTE: Be sure the Rear PTO control lever is in OFF slot when starting the engine.

4.MID PTO CONTROL LEVER (IF EQUIPPED) – Move the lever forward to engage the MID PTO. Move the lever rearward to disengage the Mid PTO.

NOTE: Be sure the Mid PTO control lever is in OFF slot when starting the engine.

NOTE:

1.The Rear and Mid PTO shaft can be operated at the same time.

2.When not using the Mid PTO shaft, cover the shaft with the Mid PTO cover.