Transmission Oil Change

To change the transmission oil, use the following procedure:

1.Put the tractor on level ground, apply the park brake and stop the engine. Move the range shift lever to L position.

2.Remove the drain plugs from the transmission case.

NOTE: For best results, drain the oil when the oil is warm.

3.Replace the hydraulic filter. See Hydraulic Filter in this manual.

4.Install the drain plugs with a seal washer and tighten to a torque of 39 to 44 Nm (29 to 33 lb ft).

5.Add the recommended oil through the fill hole and check the oil level.

6. Start the engine and check for leaks.

7.Recheck the oil level after stopping the engine. If the oil level is low, add oil up to the specified level.

DRAIN

Hydraulic Filter (Hydrostatic Drive)

Change Interval ............................................

NOTE: Replace the hydraulic filter after the first 50 hours of operation and every 200 hours of operation thereafter. Your Dealer has approved genuine filters. Do not use other type filters.

Every 200 hours (See NOTE)

Hydraulic Filter

CHANGE THE HYDRAULIC FILTER AS FOLLOWS:

1.Put the tractor on level ground, move the range shift lever to the L position and apply the park brake.

2.Put an oil canister under the hydraulic filter.

3.Turn the filter counterclockwise to remove. Use a filter wrench if necessary.

4.Apply clean oil to the O-ring on the new filter.

5.Install the filter. Turn the filter until the O-ring comes in contact with the case surface. Tighten the filter an additional 2/3 turn by hand.

IMPORTANT: DO NOT use a filter wrench to install the hydraulic filter. When the filter is too tight, you can cause damage to the O-ring and filter.

6.Wipe around the hydraulic filter with a dry cloth.

7.Change the transmission oil. See Transmission Oil Change in this manual.

Service

FRONT AXLE LUBRICATION (MFD)

NOTE: Change the oil after the first 50 hours of operation and then every 200 hours of operation.

Front Axle Oil Level

To check the front axle oil level, put the tractor on level ground. Remove the oil level plugs located on both gear cases. The level plug is located on the rear of the both gear cases. If the oil level is low, add the recommended oil through the fill hole located on the RH side of axle housing until the oil begins to flow out of the level plug holes.

Front Axle Oil Change

1.To change the front axle oil, put the tractor on level ground. Put the range lever in L, engage the park brake and stop the engine.

NOTE: For best results, drain the oil when the oil is warm.

LUBRICATION/FILTERS/FLUIDS 16 Series, Model - 2216