BRAKE PEDAL ADJUSTMENT

Service Specifications

Brake Pedal Check and Adjustment Interval.....Every 200 hours or yearly Free Pedal Movement Specification ..................................25 mm (1 inch)

Brake pedal free play is very important and must be checked at the recommended intervals. If there is no free movement, the brake shoes will wear quickly. If there is too much free movement, accidents may occur. If there is not the same free movement between LH pedal and RH pedal, it may cause serious accidents.

Put the tractor on level ground, move the range lever in the L position. Stop the engine.

Loosen lock nut and rotate the brake rod to make a free play of 20 to 30 mm (0.79 to 1.18 in.) at the brake pedal. With this much play obtained, tighten the lock nut.

BRAKE

ROD

Raise Stop Setting Position

RAISE STOP

If raise stop setting position is incorrect, the hydraulic pump might be damaged. Therefore carefully adjust as below.

Max. position by hand

Stop position by hydraulic

5 ~ 10 mm (0.2 ~ 0.4 in)

1.Disconnect LH and RH lift rods from the lift arms.

2.Start the engine.

3.Move the hitch control lever rearward to raise the lift arm to the maximum lifting position.

4.With the arm so raised, stop the engine.

5.Check a free play of the lift arm to be 5 to 10 mm at the tip of the lift arm by hands.

6.If the insufficient free play is available, move the raise stop forward and check again with the same procedure as before.