OPERATING CONTROLS

Control Switches

1.STARTER KEY SWITCH — The starter key switch can be removed with the switch in the OFF position. Four position switch as follows: position–(OFF) position–(HEAT) & (ON) position –(START) Turn the key fully clockwise against the force of the spring in the switch. The starter motor will turn the engine. Release the key immediately when engine starts.

Engine and all lamps except the turn signal and flasher lamps are turned off.

First position clockwise from OFF. In this position (Engine not running) energizes the glow plugs. The charge indicator, glow plug indicator and oil pressure indictator will illuminate. The fuel gauge and temperature gauge will show correct values.

NOTE: To prevent operation by persons not authorized and the possible discharge of the battery, remove the starter key when you leave the tractor.

IMPORTANT: Do not keep the starter key switch in the ON position for a long period of time when the engine is not operating.

2. ENGINE SPEED CONTROL LEVER – Move the engine speed control lever to the rear to increase engine speed. Move the engine speed control lever forward to decrease engine speed.

3. LAMP SWITCH – Three position switch as follows:

–ALL lamps are OFF. (Turn signal and flasher lamps can be turned on.)

–First position clockwise illuminates instrument panel lamp and rear red lamp.

–Second position clockwise illuminates headlamps, instrument panel and rear red lamp. Use dimmer switch to dim or brighten the head lamps.

4. DIMMER SWITCH – Move the dimmer switch to dim or brighten the head lamps, when lamp switch is in second position.

–Move the switch up to brighten the head lamps.

–Move the switch down to dim the head lamps.

5. FLASHER CONTROL BUTTON – To flash the Flasher Lamps whenever the tractor is operated or traveling on roads. Push the button to energize the lamps.

6. TURN SIGNAL SWITCH — To indicate that you are going to turn the tractor to the RIGHT, move the turn signal switch up. To indicate that you are going to turn the tractor to the LEFT, move the turn signal switch down. Center position is OFF.