Control and operation

The access and the outfit of the cab

3.2.5Sunshade

You can pull up or down the cab sunshade(s) 1 and set it for individual use.

The access and the outfit of the cab

3.2.6Emergency exit

Only in case of emergency, you can use the rear window 2 of the cab as an emergency exit.

Break the rear window 2 with the emergency hammer 1

The access and the outfit of the cab

3.2.7Internal lighting

Fig. 3-38 Internal lighting switch button

The internal lighting is switched to on through the S41 button on the control board.

Switch to on the internal lighting

Push the S41 button.

Switch to off the internal lighting

Push the S41 button again.

3.2.8Fire extinguisher

The interior of the cab is fitted with fixing points allowing the mounting of a fire extinguisher. These fixing points are on the left of the rear window.

It is the responsibility of the owner of the machine to decide if it must be fitted with a fire extinguisher or not, considering the operating conditions and the regulations which apply in the country and at the point of use of the machine.

Caution!

If your machine is fitted with a fire extinguisher: Always comply with the operating guide on the body of the extinguisher, Make sure, all the inspections of the fire extinguisher which are prescribed by the regulations applicable to the operating place of the machine are accomplished.

The access and the outfit of the cab

3.2.9Windscreen

Windscreen wiper

Operate the windscreen wiper

Make sure that the ignition key is switched to on. Push the button.

Intermittent mode is activated.

First LED in the button comes on.

Push the button again.

Continuous mode is activated.

First LED in the button goes off.

Second LED in the button comes on.

Press the button a third time.

Windscreen wiper is switched off. LED in the button goes off.

Set the interval time for the intermittent switching

You can set the interval in the submenu "Wiper" of the monitoring display.

Windshield washer installation

Operate the windshield washer

Make sure that the ignition key is switched to on.

Push and hold the button.

Washing water is sprayed onto the windscreen through the outlet nozzles. Windscreen wiper runs continuously.

First LED in the button comes on. Release button.

First LED in the button goes off. Washing water is stopped. Windscreen wiper finish its cycle.

Control and operation

The access and the outfit of the cab

Fill