Control and operation

3.1.4Cab control board

S184 High voltage OFF

S185 24V Safety battery Greasing:

S189 Front sheet heating (optional) A15 Greasing module

S207 Control ON 400V

S208 Control OFF 400V Air conditioning:

S233 Manual preheating of electrical boxes (if applicable)

S234 Additional heating (optional)

S235 Foot board heating (optional)

U103_1 Module air conditioning

Disable access ladder or trap control lock

For further information about correct use of this function, refer to section "Entering or leaving the cab" or "Service Trap" of this manual.

Safety operation functions

For further information about correct use of these functions, refer to section "Emergency and safety operations" of this manual.

3.1.5Monitoring display

S256 Rotary switch for control selection (if installed) 1 Screen 3

Screen

Note!

The screen luminosity is automatically adjusted depending on the environmental luminosity detected by the sensor 3

Control buttons

The control buttons F1, F2, F3, F4, F5, F6, F7 and F8 allow to switch between the different menus and to use the functions available on the display.

Each button is aligned with the menu or function (represented on the bottom of the screen) it is associated with.

3.1.6Menus and functions of the display

Main screen

The main screen comes on first when the machine is started. It shows different information and gives access to the machine menus and functions.

Push the "Main screen" button to go back to this menu from all others menus.

The main screen is divided into four fields:

General indicator field

1 General indicator field

The upper field 1 shows time information and general indicator symbols. Each symbol has a specified location on the field. If two symbols must flash on the same place, they flash alternatively.

For symbols description, refer to the section "Indicator and error warning symbols".

Dials and error warning symbols field

2 Dials and error warning symbols field

The central field 2 shows measured values and error warning symbols. Dials

The measured values that follow are represented with dial indicators: