Control, operation

Working with the machine

Operating instructions

Press down rocker switch S382 on the left joystick. The fine control is activated. The indicator light H307 lights up. The fine control is activated. Set the pump flow with knob R76: Position 1: high pump flow, maximum working speed Position 2: low pump flow, minimum working speed. Operate the attachment and check the speed.

3.4.5Locking the superstructure

Locking

When driving on public roads, transporting, taking out of service or carrying out maintenance and repair work, the superstructure must be locked to the chassis. Locking of the superstructure happens automatically with the help of a hydraulic locking pin.

Locking:

Rotate the superstructure in the direction of travel parallel to the chassis. If necessary, correct the position of the superstructure until the locking pin 1 is located centrally to the pillow block 2.

Switch off servo control S35 or push the safety lever up. The locking pin 1 extends, the superstructure is locked (B). When the diesel engine is shut down, locking pin 1 also extends.

Unlocking:

Switch on servo control S35 and push the safety lever down. Locking pin 1 retracts, the superstructure is released (A).

3.4.6Working position

Work with the machine is generally to be carried out over the rigid axle.

Caution!

Parking brake S16 may not be applied. A buzzer sounds as a warning signal when the parking brake is applied. Preselector switch S263 for travelling forward and reverse must be in position 0

Press down fully on brake pedal 6 until the retainer 1 engages.

To lock the oscillating axle:

Turn switch S75 to position I. The oscillating axle is completely locked. - or -

Turn switch S75 to position A. Lock the oscillating axle via the brake pedal.