PARKING MACHINE

Warning

● Avoid sudden stops. Leave as much room as possible when stopping.

● Park the machine on firm level ground. Avoid parking the machine on a slope. If the machine must be parked on a slope, put blocks under tracks and dig the work equipment into the ground to prevent the machine from moving.

● If the work equipment lever is touched by mistake, the work equipment or machine may suddenly move and cause serious personal injury or accident. Always set the safety lock lever securely to the LOCK position before standing up from the operator’s seat.

3.Set the work equipment in the posture shown in the diagram on the right.

4.Set safety lock lever (3) in the LOCK position.

Check After Finishing Work

Check the engine water temperature, engine oil pressure, and fuel level on the machine monitor.

Locking

Always lock the following places.

(1)Door of operator’s cab

Always remember to close the window.

(2)Fuel tank filler port

(3)Battery box cover

(4)Left side door of the machine (7 positions)

(5)Right side door of the machine (2 positions)

(6)Operator cab under box door

(7)Engine hood (3 positions)

(8)Box for storing emergency escape ladder

(9)Hydraulic tank filler port

REMARK

Use the starting switch key to open and close all these places.

Transportation

When transporting the machine, observe all related laws and regulations, and be careful to assure safety.

Precautions For Transportation

WARNING

This machine must be divided into several units for transportation. When transporting the machine, please consult your Komatsu distributor.

Removal And Installation Of Mirrors

Mirrors are installed to the positions shown at right (The one marked with (A) is optional). When removing and installing them for replacement or transportation, observe the following procedure.

Removal

1.Loosen mounting nut (2) of mirror (1), and remove mirror (1) from support (3).

2.Remove bolt (4), then remove support (3) and clamp (5) from the handrail.

Installation

Carry out installation in the reverse order to removal.

● The mirror in the diagram on the right is optional (A).

Lifting Machine

Warning

● Never carry out the lifting operation with any person on the machine.

● Always make sure that the wire rope used for lifting the machine is of ample strength for the weight of the machine.

● When lifting the machine, pay careful attention to the center of gravity to maintain the balance.

Parts For Transport

The dimensions in the diagrams are given in millimeters. For ease of transport, the machine may be disassembled into the parts shown in the diagrams: the body, operator’s cab, track frames, ladder, platform, attachments and counterweight. Ask your Komatsu distributor to carry out the disassembly work.