Hard drive

Description

120-GB, 5400-rpm

80-GB, 5400-rpm

Spare part number

435775-001

435773-001

Before disassembling the computer, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 31). Remove the hard drive:

1. Position the computer with the front toward you. 2. Loosen the two Phillips PM2.5×8.0 screws (1) that secure the hard drive cover to the computer. 3. Lift the left side of the hard drive cover (2), swing it to right, and remove the cover. The hard drive cover is included in the Plastics/Hardware Kit, spare part number 448341-001.

4. Grasp the Mylar tab (1) on the hard drive and slide the hard drive (2) to the left to disconnect it from the system board.

5. Remove the hard drive (3) from the hard drive bay.

6. If it is necessary to replace the hard drive bracket, remove the four Phillips PM3.0×3.0 hard drive bracket screws (1) from each side of the hard drive. 7. Lift the bracket (2) straight up to remove it from the hard drive.

Reverse this procedure to reassemble and install the hard drive.