NOTE: apply the angle orientation the tubes (12) and 13) shown in figure

from CNH Hydraulic Standard Provision Kit 321F HS 321F STD W80C W80C HS Wheel Loader Instructions Manual

NOTE: apply the angle orientation the hoses (17) and 18) shown in figure

4 - PRE-ASSEMBL Y

PREP ARING FOR ASSEMBL Y

Preparation

Park the machine a level surface. Lower the bucket the ground. Place the direction - - travel switch in neutral position. Stop the engine and apply the parking brake. Place the wheel chocks against the tires prevent machine movements. T urn the key switch the position. Move the joystick in all directions release the hydraulic pressure. T urn the ignition key the OFF position. T urn the master disconnect switch the OFF position.

NOTE: apply the angle orientation the tubes (12) and 13) shown in figure

Next Article

NOTE: apply the angle orientation the hoses (17) and 18) shown in figure

4 - PRE-ASSEMBL Y

PREP ARING FOR ASSEMBL Y

Preparation

More articles from this publication:

NOTE: apply the angle orientation the hoses (17) and 18) shown in figure

Route the two hoses (14) along the right side the loader arm. Secure the two hoses (14) the loader arm means the two plates (9) , the two clamps (7) , the two washers (10) , and the two bolts .

Reassembly the plate (P1) and the mounting blocks

This article is from:

CNH Hydraulic Standard Provision Kit 321F HS 321F STD W80C W80C HS Wheel Loader Instructions Manual