1 minute read
table
K
P
O 4
5 Disassembling bale twister from wrapping table
NOTE!
It is recommended to use a block and tackle to move heavy parts.
–Switch on tractor engine. –Lower wrapping table: • Set three-way valve to position II (refer to decal). • Turn emergency stop switch (K) to release wrapper from its safety position. • Press "Raise/lower wrapping table" button (P) in
Uniwrap control box: that triggers "Raise/lower wrapping table" function. • Press key (O) to lower wrapping table until bale twister disengages from holders.
DANGER!
Risk of fatal injury. If bale twister falls accidentally, this can cause serious injury. ☞There must be no one in bale twister swivel area when it is triggered by control box.
• Press emergency stop switch to clamp wrapper and make it safe. –Switch off tractor engine. –Remove ignition key. (Fig.5,6)
R
V C
–Remove bale twister (C) from right (Q) and left (R) holders. (Fig.6)
–Swing clips (V) downwards. –Jam clips (V) in position with original screws(W). Tightening torque: 83.5 Nm
(Fig.7)
