1 minute read
Shredder drum gearbox
from Claas QUANTUM 6800 SQUANTUM5500 S-18QUANTUM 5500S-16QUANTUM 5500 S QUANTUM 4500 S Operator’s Manual
68
81
83
73073
82
QUANTUM 5500 S-16/ 5500S/ 4500S from serial no. 614002243
84
ON
OFF 68 69
84
73074
89
88
87 86 ON
OFF
85
QUANTUM 5500 S-16/ 5500S/ 4500S from serial no. 614002243
90 70 91 73
92
69
73083 Install the top plate(68) with rod(82) on the front plate and fasten on both sides with washer(83) and split pin(81). (Fig.25)
25
26
Install fill indicators(88) (reed contacts) on bracket(69) with two screws each.
ATTENTION!
Look out for pinch and crush points when laying out the wiring. – Lay out wiring so it cannot be pinched or crushed during operation.
Install wiring(84) through the cross member of the top plate(68) on the right side. Connect wires (ON-ON; OFF-OFF). The top reed contact is connected to the “ON” connection. Fasten wiring with self-locking straps. Insert the strap(87) with the sensor magnet through the guides of the bracket(69). Fasten strap(87) and top plate(68) with the pins(89) to the bracket(69). Secure pins(89) with washer(86) and roll pin(85). (Fig.26)
Wind tension ropes(92) around the hoop(73) at the rear. Run tension rope from the top through the eyelet(91) on the bracket(70). Attach tension rope at front to the hook(90) on the bracket(69). (Fig.27)
