Appendix B Blocks for Setpoint Configuration

This appendix contains information on the various software blocks in the EMCP 3 control. Blocks are functional groups of setpoints. Blocks can occur in multiple instances, and in order to program a setpoint, the block number as well as the instance number must be referenced.

Table 12: Blocks for Setpoint Configuration

Block # Block Name EMCP 3.2 Number of Instances

EMCP 3.3 Number of Instances

1 Engine Oil Pressure Monitor 1 1 4 Engine Coolant Temperature Monitor 1 1 6 Engine Speed Monitor 1 1 7 Battery Voltage Monitor 1 1 8 Engine Operating Hours Monitor 1 1 9 Crank Attempt/Successful Start Counter 1 1 10 Engine Protection Events Configuration 1 1 11 Generator Protection Events Configuration 1 1 12 Other System Events Configuration 1 1 17 Diagnostics Configuration 1 1 18 Automatic Start/Stop 1 1 19 Generator AC Monitor 1 1 21 Generator Over/Under Voltage 1 1 22 Generator Over/Under Frequency 1 1 23 Generator Over Current 1 1 24 Generator Reverse Power 0 1 34 Utility Breaker Control 1 1 35 Generator Breaker Control 1 1 53 Digital Inputs 8 8 56 Relay Outputs 8 8 72 Event System 1 1 75 Electronic Control Module Reduced Power Mode 1 1 88 Digital Outputs 1 2 94 Data Link - SCADA 1 1 96 Enhanced Engine Monitor 0 1 97 Event Output Functions 30 30 98 Generator AC Power Monitor 1 1 100 Service Maintenance Interval 1 1 102 Governor Desired Engine Speed Request 1 1 104 Digital Selectors 10 10

Block # Block Name EMCP 3.2 Number of Instances

EMCP 3.3 Number of Instances

105 Event Input Functions 8 8 106 Spare Analog Input 1 1 108 AVR Desired Voltage Request 0 1 109 Enhanced Generator Monitor 0 1