Shimming procedure

14:31 Progressively tighten the retaining bolts to the required torque. Keep checking that gears rotate freely during the tightening procedure. Refer to page 27 for sequence. 18 - 21 Nm ( 13 - 23 lb ft)

14:33 Refit the Pump housing , tighten the retaining bolts to the required torque. 63 - 88 Nm ( 50 - 65 lb ft)

14:35 Refit the transfer tube, tighten the three capscrews to the required torque. 18 - 31 Nm ( 13 - 23 lb ft) 14:32 Replace the pump O Ring seal.

14:34 Prepare the rear casing for reassembly by replacing the bearing cups. DO NOT fit shims at this stage.

14:36 Refit the dipstick tube and tighten the nut and seal.