Clutch shaft replacement

14:19 Fit the upper snap ring to the Pump drive shaft assembly

14:21 Replace the O ring to the support shaft assembly

14:23 Refit the Pump idler gear to the support shaft. Check that the bearing retaining circlip is on the underside. 14:20 Refit the Pump drive shaft assembly

14:22 Replace the support shaft & bearing assembly into the front casing.

14:24 Refit the Spacer to the Pump idler gear

14:25 Reinstall the three large and one small O rings to the mating face of the front casing.

14:27 Apply sealant to the mating face of the front casing.

14:29 Tighten the bolts to the required torque. 45—64 Nm ( 33 - 47 lb ft)) 14:26 Refit the Oil seal

14:28 Refit the Torque Converter housing.

14:30 Invert the casing and refit the Pump assembly.