Torque Converter Housing dismantle

4:13 Remove the Pump assembly from the transmission and recover the O ring seal 4:14 Remove the 20 Screws securing the casing.

4:15 Using suitable lifting equipment remove the rear transmission case. Lever slots are provided to assist removal. Caution! The bearing Cups and shims may fall from the case during removal

4:17 Lift and remove the Output shaft assembly. 4:16 The Transmission with the rear casing removed.

4:18 Remove the Screw and Washer from the end of the Forward High / Third clutch shaft.

4:19 Fit a suitable lifting eye to the Forward High / Third clutch shaft.

4:21 Remove the Screw and Washer from the end of the 1st / 2nd clutch shaft and fit a suitable lifting eye.

4:23 Using suitable lifting equipment remove the 1st / 2nd clutch shaft assembly. 4:20 Lift the Forward High / Third clutch shaft out of the front casing.

4:22 Lift and Tilt the 1st / 2nd clutch shaft lift out the Forward Low / Reverse Clutch Shaft (Input Shaft)

4:24 Remove the Dipstick from the tube. Remove the 3 cap screws from the suction tube supports (arrowed).