What to observe prior to assembly

Assembly

What to observe prior to assembly

Who is allowed to carry out assembly work?

Assembly work is only allowed to be carried out by personnel having received adequate training to perform these tasks. W ork on: the safety components (pressure relief valves, fire extinguishing equipment etc.) the electrical equipment (control units, signalling devices, etc.), and the hydraulic equipment (cylinders, directional control valves, hoses etc.) should only be carried out by Hazemag service engineers or by specially trained personnel. A set of different tools and devices should be available at the points of assembly, including Hoists with adequate lifting capacity Load handling devices with adequate lifting capacity Torque wrenches

Assembly notes

Observe the valid accident prevention instructions and the special safety instructions. Secure the working area. The sequence of operations during installation must be adapted to the individual conditions prevailing at the site. It is recommendable to prepare a list specifying the individual steps to follow for assembly. Caution! Serious damage can be caused to the crusher plant and the drive units due to incorrect assembly!

Caution! Please take care to observe the respective separate operating manuals (i.g. motors etc.)!

Notice! Blows on the motor shaft will damage the roller bearings! Therefore always use a mounting and pulling-off device for installation and removal of the coupling parts! Dirt could enter the couplings if the O-rings of the flange plate are not correctly installed. This can result in serious damage to the couplings. Insure that the O-rings are in the correct position during installation of the flange plate.