2 minute read
MACHINE OPERATION
Template Date: 1994_04_29Template Name: OM_1_col
TRIM THIS EDGE
ENGINE OPERATION
When the engine has started and before beginning work, the following procedure must be observed: -Let the engine run at idle speed until the engine reaches normal operating temperature. -Move the engine throttle button to the maximum speed position. Once normal operating temperature has been reached, check the following: -The exhaust smoke is normal. -There is no abnormal noise or vibration. -There are no oil, fuel or water leaks. The engine should be run at full speed when operating conditions permit. The operating speed of the machine and of the attachment should be controlled by means of the control levers. Check the systems display and control panel regularly.
Stop the engine immediately if one of the following situations occurs:
-Sudden increase or decrease in engine speed. -Abnormal noise. -Black smoke at the exhaust. -A message appears on the display screen and the audible alarm device sounds.
94
TRIM THIS EDGE LEFT PAGE
OPERATING THE MACHINE IN COLD WEATHER
Follow the recommendations made below:
Batteries
They should be fully charged.
Fuel
a) To prevent condensation forming and water getting into the fuel system, fill the fuel tank after each day’s work and drain off any water before starting the next day’s work. b) To prevent crystals forming at -2°C, use fuel which is rated for the ambient temperature or add an appropriate antifreeze to the fuel. See “Fluids and lubricants”, in the “Lubrication/Filters/Fluids” Section.
Engine oil
It should be of the right viscosity for the ambient temperature. See “Fluids and lubricants” in the “Lubrication/Filters/Fluids” Section.
Hydraulic fluid
The viscosity must correspond to the ambient temperature conditions. See “Fluids and lubricants” in the “Lubrication/ Filters/Fluids” Section.
Coolant solution
It should be suitable for the ambient temperature and contain a minimum of 50% ethylene glycol solution. See “Fluids and lubricants” in the “Lubrication/Filters/Fluids” Section.
OPERATING THE MACHINE IN HOT WEATHER
Follow the recommendations made below: 1. Keep the coolant at the correct level in the coolant reservoir and in the radiator. 2. Use the correct solution of ethylene glycol and water in the cooling system. 3. Test the radiator cap before hot weather starts. Replace the cap as required. 4. Clean all dirt and debris from the radiator, cooler and engine area. 5. Check the condition of the fan drive belt. 6. Check the dust valve in the air cleaner frequently during extreme dust conditions. 7. Use lubricants of the correct viscosity. See “Fluids and lubricants” in the “Lubrication/Filters/Fluids” Section. TRIM THIS EDGE
95
TRIM THIS EDGE RIGHT PAGE
