1 minute read

LOADER CONTROL LEVERS

Priming the Turbocharger Lines with Oil Engine Speed

Do not operate the engine at idle speed for long periods. This can cause a low operating temperature. A low operating temperature can cause acids and deposits in the engine oil.

B4032291T

1. Disconnect the wire from the fuel injection pump solenoid.

2. Actuate the starter motor for about 15 to 20 seconds until there is oil in the lines.

3. Connect the wire to the fuel injection pump solenoid. TRIM THIS EDGE

55

TRIM THIS EDGE

RIGHT PAGE

Alt= to hide template informationAlt+ to display template information

Template Name: OM_1_colTemplate Date: 1994_04_29

Template Date: 1994_04_29Template Name: OM_1_col

Alt+ to display template informationAlt= to hide template information

TRIM THIS EDGE

STOPPING THE ENGINE AND PARKING THE MACHINE

Secondary Steering (If Equipped)

WARNING: Jumping on or off the machine can cause an injury. Always face the machine, use the hand rails and steps, and get on or off the machine slowly. SA038

1. Before you leave the machine, make sure the machine is parked on level ground.

The machine must be on level ground before you do scheduled maintenance.

IMPORTANT: If you must temporarily park the machine on a hillside, put the front of the machine toward the bottom of the hill. Make sure the machine is behind an object that will not move.

2. Lower the loader to the ground.

3. Shift the transmission direction control to NEUTRAL and apply the parking brake. 4. Run the engine at idle speed for three to five minutes to decrease the temperature of the engine and turbocharger.

5. Turn the key switch to OFF and remove the key.

6. If your machine has a cab, lock the cab door.

7. Turn the master disconnect switch to

OFF.

The secondary steering system will automatically engage to allow you to steer the machine if the primary steering system stops working. If the secondary is activated, move the machine to a safe area and then stop the machine immediately and repair the problem.

The secondary steering system will function only when the key switch is in the ON position. Turn the key switch to the OFF position to stop the secondary steering motor.

NOTE: The secondary steering system is not intended for continuous use.

56

TRIM THIS EDGE

LEFT PAGE

This article is from: