1 minute read

FLUID LEVELS EACH 10 HOURS OR DAILY SERVICES

Engine Crankcase

Check oil level shortly after engine is warm and has been stopped. Remove the engine oil dipstick (2), and check oil level. If the oil level is below the minimum mark or above the maximum mark, do not operate the engine. Add oil if necessary through the filler neck (1).

1 2

Engine Coolant Level

Check coolant when engine is cold. Make sure coolant is visible in sight glass on expansion tank. If necessary, add coolant to the expansion tank. Turn the radiator cap slowly to remove pressure. Add coolant until level is at the bottom of the filler neck. NOTE: Never add anti freeze to cooling system without checking existing level of protection. Add coolant as necessary to bring it to the proper level. Tighten radiator cap.

1. ENGINE OIL FILLER 2. ENGINE OIL DIPSTICK

Radiator

WARNING: Fluid under pressure. Turn the cap slowly to relieve pressure before ! removing or until the pressure has been relieved. The coolant may boil over and cause personal injury.

Transmission Fluid Level

Check the transmission oil level when the oil is hot and the system is charged. Place transmission in NEUTRAL, keep the engine idling and apply parking brake. Turn the handle counterclockwise to loosen the cap. Remove the cap and check oil level with the dipstick. Add oil as necessary to bring it to the proper level. Make sure the cap is tight on the filler neck after checking oil.

ENGINE RUNNING WARM

WARNING

HOT LIQUID UNDER PRESSURE HAZARD

Service when cool.

329044A1 TRANSMISSION DIPSTICK

This article is from: