Bow Platforms

Aerator timers are built into the aerator systems on some models. The AERATOR switch on the dash panel has three positions: MAN (manual), OFF (in the center), and AUTO (automatic). The manual position turns the pump on or off, while the automatic position turns control over to the timer. Fixed interval timers have no adjusting knob for “off” time. It is preset at approximately 3 minutes with the “on” time about 1 minute. NOTICE

When using dual recirculating aerated livewells, do not use recirculating mode forboth livewells when the boat is out of the water orrunning at high speed. Doing this may cause all waterto be pumped from the aft livewell to the forward livewell.

Baitwells

Your Alumacraft may be equipped with one or more individual baitwells or have removable baitwells located in the livewells. Baitwells are actually miniature livewells used to keep your minnows, leeches and other aquatic bait fresh and lively. The baitwell is filled by running the livewell aerator pump. To quickly fill the baitwells, adjust the livewell valve for less output. The aerator valve in the baitwell must also be adjusted to regulate the desired flow and prevent drainage through the overflow drain or standpipe. Remember to aerate the baitwell regularly. The livewell aerator timer will also control the aeration of the baitwells. Close the baitwell valve when not in use. Make sure all bait is removed from the baitwells before draining, and then remove the drain plug or standpipe. Replace the plug or standpipe before refilling. Your baitwell system aerates the water by continuously pumping freshwater into the well. The spray head breaks the water into many small streams that splash into the water, thereby introducing oxygen into the baitwell. To fill the baitwell, open the valve and activate the baitwell pump. The water level will be maintained to the height of the overflow. To empty the baitwell, turn off the baitwell pump and remove the drain plug or standpipe. NOTICE

The desired water level in the baitwell can be permanently changed. If you wish to lowerthe level, saw off the standpipe to the level that best suits you.

BOW PLATFORMS

The optional bow casting platform allows you to transform the normal bow rider seating arrangement into a fisherman’s bow pedestal seat. To use the bow platform you must first remove any bow seat cushions and store them. Next, place the bow platform into the bow of the boat. Slide the platform forward while retracting the two locking bolts. The locking bolts are located under the platform, to the rear on either side. As you slide the platform forward, be sure the platform’s front retaining plate engages the metal lip of the seat. Engage the locking bolts into the lock holes and turn the bolts to lock them in place. Pull on the platform so you are sure it is locked and stable. Place the bow seat pedestal into the base and lock it in. Check again to be sure the platform is locked in place. You are now ready to fish from the bow of the boat. To remove the platform, just reverse the procedure.

WARNING

Neversit on the bow casting seat when the gasoline engine is operating. Passengers using seats on high platform locations while running at more than trolling speed could be thrown overboard, resulting in severe injury ordrowning.