9 Signs that your concrete cutting saw need repair

9 Signs that your concrete cutting saw

A concrete saw is a power tool used to cut concrete, bricks, asphalt and other solid materials. It's also known as the consaw or the road saw. The blades of a concrete saw are tipped with diamonds due to the fast cutting of hard materials. Concrete saws are better than conventional saws. Concrete saws are important for the construction industry daily. It is used to cut concrete and another masonry in a precise and secure manner. It is used very frequently for construction and remodelling work.

Hard to start Air filter, starter, filter, carburettor, muffler, spark plug and gasket. Also, make sure that you use fresh fuel and that it is mixed to the correct ratio with your oil for your twostroke engine. After 90 days, after leaving the pump, the fuel will start to go bad. Bad fuel will trigger a difficult starting situation.

If you think that the fuel has gone wrong, substitute it with fresh fuel. But if still there is a problem you should immediately call

Blade wobbles If the blade of your concrete saw is wobbling during a cut, it can impact the accuracy of your work and make life very difficult. Call the technician and get it to repair.

The blade won't spin If the blade does not rotate on your concrete saw, this could be due to the malfunction of the following parts: Belt, bearings, pulley, motor, brushes, clutch or clutch drum. Get it repaired by the professional.

Vibrates excessively The concrete saw that vibrates excessively will make the saw difficult to control and cause more damage to the saw itself. This is a significant symptom that needs to be resolved. Don’t delay and call the technician immediately.

The engine rotates but the blade doesn't If the engine in your concrete saw rotates, but the blade does not rotate, check the belt, clutch and clutch drum.

Concrete saw start, run for a while, and then die Do you see that your concrete saw starts, runs for a while, and then dies? Call a professional immediately and get the job done.

Wrapping it up!

Concrete saws are important for the construction industry daily. It is used to cut concrete and another masonry in a precise and secure manner. It is used very frequently for construction and remodelling work.

Disclaimer: This is a generic Information & post; content about the services can be changed from time to time as per your requirements and contract. To get the latest and updated information, contact us today or visit our website.

Office Address Unit 36, 85 – 115 Alfred Road Chipping Norton NSW 2170 Office Contacts Email: info@elitediamondtools.com.au Phone: 0449 556 386