The underfloor heating system is one of the most efficient ways to heat your home at a low cost.

A "MEGA Flow" can connect with a gas boiler, which is a manufacturer name for an unvented hot water vessel.

These are connected straight to the incoming water mains which give you a high pressure supply of hot water.

THE MEGAFLOW MUST BE INSTALLED (SECTIONS 2 - 5), COMMISSIONED (SECTION 6) AND MAINTAINED (SECTIONS 8 10) BY A COMPETENT INSTALLER IN ACCORDANCE WITH BUILDING REGULATION G3 (ENGLAND AND WALES), TECHNICAL STANDARD P3 (SCOTLAND) OR BUILDING REGULATION P5 (NORTHERN IRELAND) AND THE WATER FITTING REGULATIONS (ENGLAND AND WALES) OR WATER BYELAWS (SCOTLAND).

FOLLOWING INSTALLATION AND COMMISSIONING, THE OPERATION OF THE HEATER SHOULD BE EXPLAINED TO THE USER (SECTION 7) AND THESE INSTRUCTIONS LEFT WITH THEM FOR FUTURE REFERENCE.

The Mega flow boiler system is operated with a particular brand of cylinders and boilers called Megaflo. The water sits around the tank until someone puts the boiler on. When it comes to the cylinder that heats the water, it gets heated up and then sent to the taps. This process involves an immersion heater made of copper or stainless steel which heats the water either by the boiler, or by the electric water heater.

The expanded facility of the mega flow cylinders controls the pressure from getting too high.

•

•

•

•

•

•

•

•

A big advantage of the mega flow boiler is that they extinct the traditional water heating system with poor water pressure The vent pipe draws the water from the mega flow cylinder using the gravity force and brings them to the taps for usage.

Several hot water taps at the same time is made possible. If you are in a joint family this will be helpful to use the shower, bath and sink wish at once by all the family members.

Enough speed when compared to the traditional mega flow cylinders and they tend to be less noisy with that of the traditional mega flow systems.

It is suitable if your home doesn’t have a sufficient gas supply. This mega flow cylinder helps in heating the water with the immersion heater.

This unvented cylinder system is completely sealed to avoid the water from getting contaminated as they stay in the tank for long days.

Less risk in subsequent flooding when they burst and frozen loft pipes.

You don’t have to rely on gravity when you use mega flow boilers, hence it can be put up anywhere you like.

The air in the bubble compresses as the water expands, increasing the pressure in the system. Both are highly effective but require certain safety measures to be in place in order to reduce the risk of possible danger if the system becomes faulty.The average or ideal temperature set by the controls are usually 60-65 degrees celsius.There is a temperature/pressure relief valve at the top of the tank, so that water can be vented if it becomes too hot.If the pressure of the system is too high or the expansion of the system is faulty, there are expansion relief valves to ensure the pressure never becomes dangerously high.

Anything is considered safe in the way that we handle them. The Megaflow cylinders are incorporated with great safety measures. There is a temperature and a pressure release valve that indicates when there is an undesirable change with the boilers that hits unsafe temperature level. These cylinders must be installed by a proficient and experienced G3 engineer; and it is a legal requirement in the UK that all these installations must be certified and registered with the local Council.

citygasheating@hotmail.com

07951203901