Tel 1300 533 000 www.primeled.com.au
Installation Instruction
PL-PRA13WR Voltage
AC240V 13Watts
Power Beam Angle
50 degrees 1pc Epistar COB LED
LED Lumens
835lm-900lm
Gimable
15 degrees
Colour
Warm White / Neutral White
Housing Materials
White / Silver Aluminum
Colour Temp
WW: 3,000K / NW: 4,000K
MUST BE INSTALLED BY LICENCED ELECTRICAN. PLEASE READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING PRODUCT. INSTALLATION INSTRUCTIONS Always disconnect the mains power before commencing installation 70mm hole saw
1.Cut the installation hole of 70mm-90mm into the ceiling. (Figure 1) 2.Connect the Dimmable LED driver to the downlight. (Figure 2) 3.Place the Dimmable LED driver and LED downlight into the ceiling.
FIG 2
FIG 1
(Figure 3 and Figure 4)
4.Adjust the gimbals to be suitable for your application. (Figure 5)
to LED driver
Please ensure all the clearance values are maintained after 15
installation for the LED downlight, LED driver, insulation to LED downlight
and any structural members. (See Clearance information section)
FIG 4
FIG 3
FIG 5
Clearance Information
LOCATION
DESCRIPTION
Notice:
50mm (Minimum)
Clearance between the top of recessed luminaire and combustible materials
1. This downlight is only for indoor application.
B
25mm (Minimum)
Clearance between structural member
3. For any further information please contact PRIMELED.
C
25mm (Minimum)
Clearance between thermal insulation and luminaire
A
DISTANCE
2. Don’t look at the light directly when the downlight is on.
N30772