62
Make it BOX FRAMES This is one of the simplest and most adaptable ways to make basic box frames – just ensure the four pieces are cut to exactly the same length. For our boxes, we cut four pieces 300mm long, 200mm and 150mm, but you can adjust the sizes to suit. It should be noted that while gluing and nailing the joints keeps them secure, the frames are best kept under about 350mm square so they don’t become too heavy. Avoid using them to display heavy items – they’re best for stashing lighter bits and pieces.
1
2
3
4
5
6
On the pine, mark 300mm from the end and use a mitre box with handsaw to cut. Use this piece to mark and cut three more pieces, checking to make sure they’re the same length.
TOOLS & MATERIALS
Safety equipment (mask and eye and ear protection) Tape measure and pencil Mitre box with handsaw 150mm combination square H ammer 1.2m length of 64mm x 19mm DAR pine• (makes a 319mm-square frame) T imber adhesive Painter’s tape Cloth 30mm x 1.6mm bright bullet head nails 180-grit abrasive paper with sanding block Saw-tooth hangers with supplied nails
Your DIY toolkit
Dry-fit the frame by positioning a side flush against the base, the top flush against the side, the remaining side flush against the top and over the base. Tip: Work on a flat surface to keep the joints straight and accurate.
2
Apply adhesive along the endgrains and reassemble the frame. Wrap tape firmly around the middle, checking the joint angles with a combination square. Wipe away excess adhesive with a damp cloth and then set aside to cure.
1
Working around the sides, hammer two nails into each joint, 10mm from the ends and sides, then remove the tape. Tip: Nailing too close to the sides can split and damage the pine.
3
1 Zenith ‘SureHook’ 5/25kg brass plated 49 piece wallmate picture hanging starter kit, $23.54, I/N: 3930448. 2 Paslode 30mm x 1.6mm 100g bright steel bullet head nails, $3.98/pack of 190, I/N: 2360368. 3 Empire ‘True Blue’ 150mm combination square, $16.75, I/N: 5660527. 4 Claymark 1.2m x 64mm x 19mm standard grade dressed pine, $6.50, I/N: 8401490•. Some products are not available at all Bunnings stores, but may be ordered. bunnings.com.au |
bunnings |
bunnings
Use 180-grit abrasive paper with a sanding block to remove any adhesive from inside and outside the frame, rounding over the edges and corners slightly for a professional finish.
On the back of the frame, measure along the top to find the centre. Position a sawtooth hanger, tap in the supplied nails and hang on an installed screw to suit your wall type. Tip: To support larger frames, position D hooks either side.
• Timbers vary by state and territory; contact your local store for further information.
4
