Page 1

ARDUINO (blink)


Ohm’s Law V = IR


What is Arduino?


ARDUINOS http://arduino.cc/en/Main/Products


Basic Hardware Introduction


Digital Output x 12(14) Analogue Output x 6 (LED, Servo…) USB Port

4

5 7 Reset POWER

1

ATmage328

6 2

3.3V/5V Power(+) Ground(-)

Micro Controller

3 Analog in = Input x6 (Sensor, potentiometer… )


USB Messages 5

OUTPUT

4

7 *POWER input

1

ATmage328

6 2

POWER Output

Reset BRAIN 3

Input


http://www.arduino.cc/


Choose the Operation Platform You Use to get the Application and INSTALL!!!


If you have any troubles with running the application Follow the steps


Instead of the latest version Find the old one


http://arduino.cc/en/Main/OldSoftwareReleases

Find what suits you, in my case: “arduino-1.0.5-r2-windows”


If you can Run the IDE You are good


http://arduino.cc/en/Guide/MacOSX

Come here, if you want to Know the clear process.


Otherwise, Here comes the annoying part DRIVER


Doing this while You plug in your Arduino


Window’s + Arduino Uno

Window’s + Arduino Duemilanove


Mac + Arduino Uno

Mac + Arduino Duemilanove


This Probably take Half an hour‌


Open the Application (IDE)


Looks like Processing?!


The syntax is almost the same So let’s start with Processing for warm-up


The Major things are: Variables If else For-loop


Back to the Arduino


=setup

=draw


*Plug in your Arduino

Important step 1: Choose the right BOARD


*Plug in your Arduino

Normally it’s COM3

Important step 1: Choose the right PORT


Upload & Blink


Open the example file: File > Examples > 1.Basics > Blink.


Compile

Upload


Compile

Compiling‌

Done Compiling


*Make sure you choose the right board & port before uploading‌

Upload

Uploading‌

Done uploading


Blink!!!


BreadBoard


13+ 220立

Ground-

LED: Long > + Short > --


Back to Code


/* Blink Turns on an LED on for one second, then off for one second, repeatedly. This example code is in the public domain. */ // Pin 13 has an LED connected on most Arduino boards. // give it a name: int led = 13; // the setup routine runs once when you press reset: void setup() { // initialize the digital pin as an output. pinMode(led, OUTPUT); } // the loop routine runs over and over again forever: void loop() { digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(led, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second }

Pin No.?

Set Pin as output

High = on Low = off


Try to make it blink one by one!!!

InteractiveBody Workshop_002_01=Arduino_Blink  

[Technical Study]: For developing basic kinetic or interactive design projects, participants will need to learn basic interactive technique...

Read more
Read more
Similar to
Popular now
Just for you