Epson ET 2760 | All-in-One | Setup | Printer Tech Support

Epson ET 2760 Setup When you unbox the Epson EcoTank printer 2760 carton box, you will have the following accessories along with the printer.The power cord,The ink cartridges.If you find anything missing, contact the printer manufacturer immediately. ➢ Remove all the protective tapes from the printer and the control panel. ➢ Take out the power cord and connect it to the power source.

Plug the other end of ➢

the cord to the Epson printer.

➢ Power on the printer by pressing the Power button on the control panel. ➢ Once you see the control panel light up, you will see an orange color screen, ➢ prompting you to enter the preferred language. ➢ Open the top tray of the printer and remove all the protective tape inside it. Now, ➢ press OK on the printer control panel. ➢ Now, you can proceed to install the color cartridges in the printer. ➢ Open the top tray of the printer, and on the side, you will see a small portion where ➢

you have to place the ink cartridges.

➢ You will see four color slots for each of the cartridges. ➢ Open the blue cap of each cartridge. Now, take the ink bottle, invert them vertically,

➢ and place them in the slot until you see the slots full. ➢ Repeat the steps for all the other cartridges until they are full, once down.

➢ Now, you can start the initialization of your Epson ET 2760 Setup printer. Press ➢ the question mark button on the printer’s control panel and hold it for more than ➢ 4 seconds or until you see a message on the control panel screen. ➢ The initialization will take about 10 minutes, after which you can start seeing the ➢ options on the control panel.

TO KNOW MORE ABOUT : Driver instal | Manual Download | Wireless Setup | Scan Setup And More Refer The Link https://airprint.us/epson-et-2760/