71
Operation Manual RehaStim 2, RehaMove 2
to activate the stimulation. If the speed of the Below this speed the MOTOmed is too low, raise stimulation is deactivated the speed up to 10 rpm. for safety. The connection to the MOTOmed is constantly checked. If the connection does not work, e.g. - the connecting cable has come out, - the MOTOmed viva2 is switched off or the communication between the stimulator and motion trainer does not exist, this window pops up.
Check the cable from the RehaStim2 to the motion trainer and make sure it is connected properly. Press any key to close the pop up window and to continue.
This screen comes up if the MOTOmed is not in start position and the Stimulator cannot take control of the MOTOmed. e.g. if a MOTOmed training session is running.
Stop the MOTOmed (press big red button start/ stop) and then "restart". The correct MOTOmed start screen says "Start screen FES programme". At the stimulator, press any key to close the pop up window and to continue operation.
The connection to the MOTOmed is constantly checked also during the training. If the connection does not work during training, e.g. the connecting cable has come out or the MOTOmed viva2 is switched off, the training is finished and this window pops up.
Check the cable from the RehaStim2 to the motion trainer and make sure it is connected properly. Check that the MOTOmed is turned on.
Check whether the right interface of the MOTOmed cockpit is activated. Please contact the manufacturer for further instructions.
Press any key to close the pop up window and continue. Please contact the manufacturer for further instructions.
Version 1.4 / 2012-09
HASOMED GmbH