YENADENT A. S. Bostancı Yolu Üzeri, Keyap Çarşı Sitesi H Blk. No:132 Yukarı Dudullu İstanbul – TURKEY Tel: +90 (216) 314 1994 Fax: +90 (216) 364 6526 www.yena.com
Yenadent D Series Installation Requirements Electrical 220 volts ± %5, 50Hz Single phase main electric input. Minimum 3 x 1.5mm Power cable line and 16 Amper fuse installation Good Grounding Class 3 ( Class 3 Grounding requirements are max 100 Ω grounding resistance and 500 V megger measuring instrument )
Compressed Air Minimum P=6.5 bar compressed air (ISO 8573-1) 240 L/min flow rate Air line From compressor to Machine must be at least 3 ¼” size Manual valve for on/off Solid impurities – Class 3 – Filter grade at least 5µm for solids Water content – Class 4 – max. Pressure dew point +3C Total oil content – Class 2 – max. Oil content 0.1mg/m³
Suction System Vacuum flow rate must be 50-220 m³/h Vacuum pressure around 22.000 Pa
Machine layout and environmental conditions Machine generates vibration while working and therefore a smooth concrete floor surface should be prepared. Only 5 mm level difference is allowed throughout the machine base. The machine surrounding should be clear . Behind the wall of the machine there should be a minimum distance of 50 cm. If humidity and temperature of the compressed air is variable, then the drying system and air coolers should be installed. Compressed air temperature should be the same as the room temperature. Ambient Temperature for machining condition should be 20-25 ºC Degree
Coolant Water ( for ceramic or metal cutting ) The machine’s water tank volume is 20 liters max . 5% of the volume is filled with cutting fluids and the rest is filled with the regular water.Cutting fluids can be found in stores that sell industrial products.
Recommendations Minimum 3 kVA Online UPS ULT 200.5-x High Vacuum module series Atlas Copco GX-2 Model air compressor