Leather Office Massage Chair Assembly Instructions

Noisy Visuals

For Queries Call: 01245 364 065 Weekdays 9:30 to 16:30

ASSEMBLY INSTRUCTIONS Executive Luxury Leather Reclining Ofď€ ce Chair with 6 Massage Points For full step by step instructions please turn to the next page

Noisy Visuals

For Queries Call: 01245 364 065 Weekdays 9:30 to 16:30

> STEP 01 Before opening the box please observe the warning labels and do not use any sharp tools to open the box as this may damage the items inside.

> STEP 02 Once you have opened the packaging lay out all of the parts and tools supplied and take a few minutes to familiarise yourself with the assembly instructions provided.

> STEP 03 Begin the assembly by turning the base of the chair upside down and inserting the chair wheels into the sockets.

This may require a little force for the wheels to slot neatly into the sockets.

Noisy Visuals

For Queries Call: 01245 364 065 Weekdays 9:30 to 16:30

> STEP 04 Turn the base of the chair the right way up making sure all chair wheels are correctly inserted. Next insert the gas lift piston into the base which should slide in easily and place the protective plastic tube over the top.

> STEP 05 To assemble the seat rst lay out the armrests and bottom

M6 X 25mm

of the seat. Secondly select the appropriate screws (4 x Screw Number 10) and attach the armrests. Right armrest will have a tted remote pocket.

> STEP 06 Next take the back of the chair and slide it into the ttings M8 X 35mm

on the armrests and fasten it with the appropriate screws (2x Screw Number 11).

Noisy Visuals

For Queries Call: 01245 364 065 Weekdays 9:30 to 16:30

> STEP 07 Once more turn the chair upside down and t the reclining mechanism. To t the reclining mechanism rst attach the

M6 X 22mm

silver xing tho the bottom of the seat using two screws and washers (2 x Screw Number 13).

> STEP 08 To t the piston rst attach it to the back of the seat by inserting the end of the piston in between the xing on the chair and x it in place by inserting a bolt trough the chair xing and the piston and tighten in place with the correct bolt (1 x Screw Number 12).

> STEP 09 Finish attaching the reclining mechanism by aligning the end of the piston with the xture we added in step 7 and putting a bolt through both. Please note you may need to press down on the lever of the mechanism to extend it.

To ensure the reclining mechanism works feed the tension cable through the hoop of the piston and x the ball on the end of the cable into the piston lever and tighten with the attached nuts.

M8 X 35mm

Noisy Visuals

For Queries Call: 01245 364 065 Weekdays 9:30 to 16:30

> STEP 10 Attach the base mechanism by simply screwing in the appropriate screws and washers (4 x Screw Number 13).

> STEP 11 To connect the cables simply connect the two white cables together then connect the remote and the power cable to their respective connections. The remote cable will be thicker than the power cable connector.

> STEP 12 Finally turn the chair the right way up and slot the top of the chair into the piston on the base of the chair and connect the chair to a power supply.

M6 X 20mm