VELOCITY ADJUSTMENT INCREASE/DECREASE Decrease Velocity STP026
VTAO26
Increase Velocity
To INCREASE your velocity (fps) using the Allen wrench, turn the Velocity Adjuster/Spring Guide clockwise. To DECREASE your velocity (fps) using the Allen wrench, turn the Velocity Adjuster/Spring Guide counter-clockwise. HELPFUL TIP: Allen wrench is provided in the spare parts kit. NOTE: The Velocity Adjuster/Spring Guide doesn’t remove from the rear of the Striker Plug. NOTE: The velocity of this paintball Marker ranges from approximately 220 - 300 feet per second (fps). Velocities will fluctuate or vary due to paintball size, climate condition, altitude, type of air source and variance in spring tension from manufacturing.
WARNING • The recommended Velocity speed should be no greater then 300 fps. Not doing so can cause serious injury if the Velocity is dangerously high. • Paintball markers are not intended to shoot any person less than 30 feet. • Never point a loaded marker at any person who is not wearing the proper face protection. • Never at any point should you look down the barrel, whether the marker is loaded or not. • Using a paintball marker outside a non designated paintball field can be illegal, and is subject to law enforcement penalties if property damage is caused by the user.
BATTERY INSTALLATION
SCR002 WRH002
GRP005
SCR002
Part Names and Numbers described in this section: Dual Texture Grip Panel (#GRP005) M4 x 8 Screw (A) (#SCR002) Battery Harness (#WRH002) Kingman Group recommends using a Spyder 9.6volt NiMH Rechargeable Battery as a power source for optimum performance and will provide a superior shot count of around 5000 to 6000 rounds. (Spyder Battery and Charger Sold Separately) NOTE: This marker is compatible with the use of 9volt batteries. Use only premium brand Alkaline batteries for best performance. (Battery Not Included) Shot counts will vary depending on the type of 9volt Alkaline battery used (2300 to 3200), choosing a premium brand battery will give the best results.
IMPORTANT: Performance will vary depending on the mode used and rate of fire achieved. STEP 1 Remove the three M4x8 Screws from the Right side grip panel. NOTE: Allen wrench provided in the spare parts kit. STEP 2 Attach the battery to the battery harness. STEP 3 Re-tighten the three M4x8 Screws. HELPFUL TIP: Please note how the parts are removed for easy reassembly.
CHARGING INSTRUCTIONS Spyder 9.6volt Battery (US LED) optional accessory To charge a Spyder 9.6 NiMH battery, the circuit board must be in the OFF position. Spyder batteries (JE1015) are not fully charged when purchased. Using the supplied Spyder LED A/C Charger (JE1029), plug the charger into the charger
9