Treatments when infected
Vires5 Greenery
Fruit, vegetables and plants can be infected because of viruses, bacteria and fungi in the ground. This can also happen from giving them water during cultivation or from diseases spreaded by the wind.
Instructions manual NRA 6781242-2012
Healthy trees give healthy fruit
Viruses, bacteria and fungi in the ground
Infection spread through the wind
Treat the plants in the rain. For 1. It is necessary to spray the plants directly as soon as symptoms start to appear. For effective use it is necessary for the effective use it is necessary for the plants plants to be totally wet. Spray in the to be totally wet. Spray in the rain or use a water cannon. Use 300 liter water per ha rain or use a water cannon. Use 300 mixed with 3% Vires5 Greenery. Do this 3 liter water per ha mixed with 3% times a day/night within 12 hours. Vires5 Greenery (with a begin Redox 2. Spray the plants directly with water value of 230-260 OrpV). Do this 3 mixed with 3% Vires5 Greenery (300 liters times a day/night within 12 hours. per ha). This should be done 3 times a
Infection caused by giving water It is only possible to stop the infection, it is not possible to cure the problem. Diseases caused by giving water are named: 'Fake diseases'. It may not be possible to keep these crops for very long. For treatment follow the steps listed above.
Vires5 Bvba, Bredabaan 926, 2990 Wuustwezel, België, EU www.vires5.com
Instructions manual Vires5 Greenery ™ © Vires5 BVba, 2012
day/night within 12 hours and 3 times within one week.
3. After that spray every week 300 liter water per ha mixed with 3% Vires5 Greenery. This should be repeated 3 times a day/night within 12 hours and 3 times within one week. The process should be continued if the sick leaves are still wizened.
Take care of viruses, fungi and bacteria
Take care of viruses, fungi and bacteria
Technical Information
Use Vires5 Greenery in wet conditions
Vires5 Greenery is treated water with a high Redox level. This product is produced by treating the water with negative ionization and a saline solution. The solution is put into a vacuum and with the electrochemical procedure it is ionized. This process results in the needed Redox level to create Vires5 Greenery.
How much Vires5 Greenery to use?
For product: Vires5 Greenery
Vires5 Greenery is an unique product to improve the quality of water in the agriculture and horticulture industry. The increased Redox level of the water will naturally take care of the viruses, fungi and bacteria. Vires5 Greenery can be used with nutrients, biocides, fungicides and insecticides.
General Treatments Vires5 Greenery
Sowing seeds
When treating soil it is best to do this early in the morning or when in rains. For every ha spray at least 900 liters water mixed with 3% Vires5 Greenery. This should be done in three steps;
To protect sowing seeds (spinach, cabbage, beans, peas) after they have been sown spray them with 300 liter water mixed with 3% Vires5 Greenery solution per ha. This should be done early in the morning or in the evening.
If further problems appear: Repeat the above 3-step treatment plan 2-3 times within one week, and use 10% Vires5 Greenery.
Seeds To protect seeds, immerse the seeds in a 3% Vires5 Greenery solution. Dry the seeds if necessary before sowing, sow within two days after immersing the seeds. • • • •
Immerse weak seeds for 1 min, Immerse hard shelled seeds for 15 min, Immerse plant roots for 1 min, Immerse pills seeds for 10 min.
If further problems appear: Spray the seedlings directly with 300 liter water per ha with 10% Vires5 Greenery, repeat this 2 or 3 times, depending on how severe the infection is.
Follow up treatment: When the plants are approximately 10 cm high, spray them with 300 liter water mixed with 3% Vires5 Greenery solution per ha. This should be done early in the morning or in the evening. If further problems appear: Spray the flowers directly with 300 liter water per ha mixed with 10% Vires5 Greenery. This process should be repeated 2 or 3 times depending on how severe the infection is. • • • •
% Vires5 in general
< 150 OrpV
5%
< 200 OrpV
4%
230 – 265 OrpV
3%
< 300 OrpV
2%
Vires5 Greenery 1.
It is best to use Vires5 Greenery in humid weather conditions. This can be early in the morning, in the mist or even better when it’s raining. However if this is not possible it is necessary to spray the plants with water until they drip. After that follow our recommended treatment programme.
2.
When you use Vires5 Greenery to grow fruit, vegetables, flowers, plants and trees, they will get stronger. Stronger plants absorb more minerals from of the ground, therefore it is important to give the plants extra minerals and nutrients to ensure the best results.
3.
When using additives, nutrients or other products together with Vires5 Greenery. The best thing to do is to measure the necessary amount of water and add 3% Vires5 Greenery. After that you can give the plants the needed additives, nutrients or other products. With pure and clean water the additives, nutrients and so on will work more efficiently leading to optimal results.
Stronger seeds, roots, plants and trees
To effectively use our product we have described ways below on how to use Vires5 Greenery in the agriculture and horticulture industry.
Soil Treatment
1. Spray 300 liter water mixed with 3% Vires5 Greenery, 2. 1 Hour later repeat step 1, 3. 1 Hour after step 2 spray another 300 liter water mixed with 3% Vires5 Greenery. (27 liter Vires5 Greenery for 3x /ha.)
Redoxlevel of water
General information
Plants ≥ 10cm high use 300 liter per ha, Plants ≥ 20cm high use 400 liter per ha, Plants ≥ 30cm high use 500 liter per ha, Plants ≥ 40cm high use 600 liter per ha.
Small plants To protect the small plants, immerse the roots before planting in water mixed with a 3% Vires5 Greenery solution. When the plants have been planted in trays. The size of the holes in the tray determine how long the plants should be dipped in the Vires5 Greenery Solution. • 0,5 cm ø holes = 30 seconds • 1 cm ø holes = 1 minute • 2cm ø holes = 2 minutes, and so on
Follow up treatment: As soon as the plants start to blossom or produce fruit or vegetables. 1. When plants are watered with a daily drip system. Add a maximum amount of 1 to 2% Vires5 Greenery to the system. This should be done before any additives are added mixed to the system. 2. You can also use Vires5 Greenery through your nutrient system. Just add 10 liter Vires5 Greenery per ha. 3. When plants are watered through a sprinker system, add 3% Vires5 Greenery to the system. Spray when plants are wet.
If further problems appear: Spray the plants directly with 300 liter water per ha mixed with 10% Vires5 Greenery. This process should be repeated 2 or 3 times depending on how severe the infection is.
depending on how severe the infection is. This can be done through the daily drip or the sprinker system in a greenhouse or with a tractorsprayer in an open field.
• • • •
Bushes and shrubs
Local problems like Erwinia can be treated by spraying water mixed with 50% Vires5 Greenery directly on the infection. This process should be repeated 2 or 3 times a week untill the infection has gone.
If further problems appear: Spray the flowers directly with water mixed with 10% Vires5 Greenery solution. This process should be repeated 2 or 3 times depending on how severe the infection is.
To protect bushes and shrubs, immerse their roots before planting in water mixed with a 3% Vires5 Greenery solution. If this is no longer possible, spray 300 liter water per ha mixed with 3% Vires5 Greenery over the bushes and shrubs.
If further problems appear: Spray the bushes and If further problems appear: Spray the plants shrubs directly with 300 liter water per ha mixed with directly with 300 liter water per ha mixed with 10% 10% Vires5 Greenery. This process should be repeated Vires5 Greenery. This process should be repeated 2 2 or 3 times depending on how severe the infection is. This can be done through the daily drip or the sprinker or 3 times depending on how severe the infection is. This can be done through the daily drip or the sprinker system in a greenhouse or with a tractorsprayer in an system in a greenhouse or with a tractorsprayer in an open field. open field.
Cutting of plants The cuttings are placed in a tray, immerse the tray in water mixed with a 3% Vires5 Greenery Solution. The size of the holes in the tray determine how long the cuttings should be dipped in the Vires5 Greenery Solution. • 0,5 cm ø holes = 30 seconds • 1 cm ø holes = 1 minute • 2cm ø holes = 2 minutes, and so on
Fruit and nut trees To protect trees, spray them water mixed with 3% Vires5 Greenery (900 liter per ha). The first time you spray with Vires5 Greenery is early in spring on 'dead wood'. The second time as soon as the blossom open. The third time as soon as fruit start to grow. Follow up treatment: After a storm or when the trees are pruned it is necessary to spray the wounds of the tree with undiluted Vires5 Greenery. If further problems appear: Spray the trees directly with 900 liter water per ha mixed with 10% Vires5 Greenery. This process should be repeated 2 or 3 times
Bulbs The bulbs should be put in water before they are planted. The size of the bulbs determine how long they need to be dipped in the Vires5 Greenery Solution. When a bulb is 3 cm in diameter, soak it for 3 minutes in the Vires5 Greenery Solution ans so on. • When using healthy bulbs, mix 3% Vires5 Greenery into the water before adding any chemicals. • When using bulbs that are infected add 20% Vires5 Greenery into the water before adding any chemicals. Follow up treatment: Spray the flowers once a week with water mixed with 3% Vires5 Greenery (300 Liters per ha). It is possible to combine Vires5 Greenery with many other products. Always add Vires5 Greenery first to ensure the best results.
Flowers ≥ 10cm high use 300 liter per ha, Flowers ≥ 20cm high use 400 liter per ha, Flowers ≥ 30cm high use 500 liter per ha, Flowers ≥ 40cm high use 600 liter per ha.
Potatoes To protect the seed potatoes, immerse the potatoes for 10 seconds in water mixed with a 3% Vires5 Greenery solution. Follow up treatment: Spray the plants twice with water mixed with a 3% Vires5 Greenery solution. The 1st time should be when the plants are 10 cm high. The 2nd time 60 days after the seed potatoes were planted. If further problems appear: Spray the plants directly with water mixed with 3% Vires5 Greenery (300 Liters per ha). This should be done 3 times a day/ night within 12 hours and 3 times within one week. The process should be continued if the sick leaves are still wizened.
Centimeters = Minutes