4B-4 PROPELLER SHAFTS
INSTALLATION Install propeller shaft(s) reversing removal procedure noting following points : • When installing propeller shaft, align the match marks. Otherwise, vibration may occur during driving. • Use following specification to torque universal joint flange. Tightening torque Propeller shaft bolt (propeller shaft No.1, No.2 and No.3 rear differential side) (a) : 50 N·m (5.0 kg-m, 36.5 lb-ft) Propeller shaft bolt (propeller shaft No.3 transfer case side) (b) : 33 N·m (3.3 kg-m, 24 lb-ft) NOTE: If transmission oil was drained for front propeller shaft removal, pour specified gear oil into transmission case to specified level.
• Grease splines of propeller shaft No. 2 and No. 3. “A” : Chassis Grease 99000-25030
• Match marks (1) are provided on slip-on spline connections of propeller shaft No. 2 and No. 3. Inserting splined end into spIined bore without regard to match marks can be a possible cause of noise or vibration of propeller shaft. Be sure to index marks.