UNDERGRADUATE REGULATIONS & SYLLABUSES 2013 - 2014 THE FACULTY OF ENGINEERING
3.1.5
(d) Any other qualification that is considered by the Department, in addition to those listed in Regulation 3.1 above. 3.1.4 LAND MANAGEMENT (a) A minimum total of 6 qualification points as calculated from Table 3.1 based on passes at any combination of ‘A’ Level or CAPE (averaged over CAPE I and II) or N1 or N2, in any two of the following: Pure Mathematics, Physics, Geography, Accounting, Economics and Management of Business, or (b) Any other qualification that is considered by the Department, in addition to those listed in Regulation 3,1 above.
OR
INDUSTRIAL, MECHANICAL AND MECHANICAL ENGINEERING WITH A MINOR IN BIOSYSTEMS (a) A pass in Chemistry at GCE ‘O’ Level or CXC, and (b) A minimum total of 8 qualification points as calculated from Table 3.1 based on passes in Pure Mathematics and Physics at any combination of ‘A’ Level or CAPE (averaged over CAPE I and II) or N1 or N2. Note that preference will be given to passes in Applied Mathematics. Technical Drawing will also be an asset. (c) Any of the following Diplomas, based on merit using the scores calculated in Table 3.1: NEC Mechanical Engineering Technician Diploma, COSTAATT Associate Degree, TTIT/UTT Technician Diploma, BCC Ordinary Mechanical Technician Diploma,
Table 3.1: Qualification Scores for Approved Certificates & Diplomas Qualification by performance in approved individual examinations (e.g. CXC, GCE, UWI)
‘A’ Level
A
CAPE1 (½∑Unit scores) I
N1*1
Qualification by performance in approved programmes (e.g Diplomas, Associate Degrees etc)*2 NEC, (CET, EEET, MET)
N2*1
A
A
A+
TTIT/UTT, CAST/UTech PreEngineering Programme
B
C
D
E
II
III
IV
B
C
D
B
C
D
V
BCC, COSTAATT
> 3.8
A
Qualification Score
5 > 3.8
4.5
A-
3.8
3.5
4
B+
3.5
3
3.5
B
3.4
3
3
B-
3.0
2.5
2.5
C+
2.9
2.5
2
C
2.5
2
1.5
C-
2.4
2
1
D
2.0
1.5
½
*1. For CAPE , N1 and N2 subjects, the final score for assessment of suitability for entry into Programmes is derived by adding the scores for each Unit of examination and dividing by 2. For other qualifications in this category the qualification points are obtained by adding qualifying scores for each subject. *2. Qualifying points used for determination of suitability for entry for qualifications with a single letter grade are obtained by doubling the individual equivalent scores. Applicants with qualifications that are not listed will be assessed on a case by case basis.
23
Return to Table of Contents Faculty of Engineering Online