Parameters
5
Parameters This section describes all setable parameters that the operator can configure to control the UE behavior in Idle mode and in state CELL_FACH and URA_PCH.
5.1
Descriptions
5.1.1
Cell Selection and Reselection accessClassNbarr ed
Indicates whether or not access restrictions apply for Access Classes 0 to 15. If access restriction is indicated for a certain Access Class, the UEs assigned to this Access Class are allowed to camp in the cell but are not permitted to enter Connected mode by sending an RRC Connection Request message.
accessClassesBar redCs[n]
Indicates if CS domain specific access restrictions apply for Access Classes 0 to 15. If access restriction is indicated for a certain Access Class, the UEs assigned to this Access Class are allowed to camp in the cell but are not permitted to enter Connected mode by sending an RRC Connection Request message with purpose to setup a CS Signalling Connection. A connected mode UE shall also check this parameter before sending an INITIAL DIRECT TRANSFER towards the CS domain.
accessClassesBar redPs[n]
Indicates if PS domain specific access restrictions apply for Access Classes 0 to 15. If access restriction is indicated for a certain Access Class, the UEs assigned to this Access Class are allowed to camp in the cell but are not permitted to enter Connected mode by sending an RRC Connection Request message with purpose to setup a PS Signalling Connection. A connected mode UE shall also check this parameter before sending an INITIAL DIRECT TRANSFER towards the PS domain.
bandIndicator
Indicates for which GSM band, DCS 1800 or PCS 1900, the ARFCN for the GSM cell is valid. The parameter is defined per GSM neighbor.
bcchFrequency
BCCH frequency code in the GSM cell. The parameter is defined per GSM neighbor.
cellReserved
Indicates whether this cell will be reserved for operator use. If it is reserved, only UEs assigned to Access Classes 11 or 15 can treat the cell as candidate for
71/1553-HSD 101 02/6 Uen B 2008-03-14
49