TEST REPORT Each machine is tested prior to shipment. These are the test results for unit . ● SPINDLE CONCENTRICITY (.0005” in max)
By:
● DOP-TO-SPINDLE OFFSET (.001” in max)
By:
● PLATEN VERTICAL RUNOUT (.0003” in TIR)
By:
● PLATEN PARALLELISM (.0004”/inch)
By:
WARRANTY This warranty extends to the supplied machine only. Ultra Tec is not responsible for any collateral losses in which the supplied equipment has been involved. The Ultra Tec Faceting Machine has a lifetime warranty, for the original purchaser, for defects in material and workmanship of all mechanical parts. Excepted are electronic components, which have a one year warranty, and parts which may require replacement because of wear, including motor brushes, flexing springs, rubber drive cones, and bearings. (If the unit is used under commercial factory conditions, the warranty periods are two years and four months, respectively). Excluded from the warranty are problems resulting from misuse, wear, modification, or accidental damage. If the unit fails to function properly, consult your representative or call the factory. If it is found to be necessary to return the unit, send it in its shipping container, prepaid, with a note that briefly describes the problem. Ultra Tec will correct the problem by repair or replacement and return the unit to you. Ultra Tec is not responsible or liable for unauthorized repairs, alterations, or any contingent damages.
ULTRA TEC MFG, INC. 1025 E. CHESTNUT AVENUE SANTA ANA CA 92701 Tel: 714/542-0608 Fax: 714/542-0627 E-Mail: info@ultratec-facet.com www.ultratec-facet.com
3