Switcher Sets

The switcher stores configuration and operation data in a number of registers that contain the individual entries for items such as memories or personality settings. These registers can be stored as a single archive file, or as a register set that contains all the individual register of that type; all memories for example. These files are stored into Sets on USB drive. Different Sets can be created for different shows or applications, allowing you to quickly locate and recall the switcher configurations. The switcher stores information in the following registers: • Memory — contains all the memories for all MEs • Custom Control— contains all the custom control banks and macros • Personality — contains all the user interface settings, such as transition rates, that are stored under the PERS menu • Installation — contains all the external device setup, and software settings for the switcher

To Store a Set

Switcher Sets can only be stored to a USB drive. The USB drive must be present before you try to store the Set. A total of 10 Sets of switcher setup information can be stored onto the same USB drive.

1. Insert a USB drive into the USB Port on the switcher. You must wait 5 seconds for the switcher to recognise the USB drive. 2. Press MENU > SAVE. 3. Use the Save knob to select the set (0-9) you want to store the switcher registers to. 4. Press the knob to select the registers you want to store to the selected set. If an (*) is shown on the menu, that register already exist in the set and will be overwritten. • ALL — store all registers to the set • Mems — store only the memory registers to the set • Cust — store only the custom control registers to the set • Pers — store only the personality registers to the set • Inst — store only the installation registers to the set

5. Press Confrm.

To Load a Set

Switcher Sets can only be loaded from a USB drive. The USB drive must be present before you try to load the settings.

1. Insert your USB drive into the USB Port on the switcher. You must wait 5 seconds for the switcher to recognise the USB drive. 2. Press MENU > LOAD. 3. Use the Load knob to select the set (0-9) you want to load the switcher registers from. 4. Press the selected set. Only registers with an (*) shown on the menu exist in the set. • ALL — recall all registers from the set • Mems — recall only the memory registers from the set • Cust — recall only the custom control registers from the set • Pers — recall only the personality registers from the set • Inst — recall only the installation registers from the set

5. Press Confrm.