Design Development

Arduino Exploration

When developing the Arduino motor, it was done through tutorials and trial and error. The first experiment displayed may be controlled by a remote that causes the stepper motor to move in response to how the controller is twisted. To allow the system to move, a code has been designed that allows the motor to reply to the controller when moved.

The following stage in establishing this method is to include it into the design itself. To allow the system to move, the stepper motor must be connected to a pulley system. The procedure must be created and tested to produce the greatest possible outcome and to allow the motor to function and perform its purpose.

Servo Motor angular or linear position, velocity, and acceleration may all be controlled precisely with a rotary actuator or linear actuator.

Male Wires

Jumper wires are used to connect components on your breadboard to the header pins on the Arduino.

USB Breadboard

With the aid of this shield, you may link your Arduno projects through USB to a computer, storage devices, and other input devices.

Potentiometer

This is used to manually adjust the value of something on the Arduino project. In this circumstance it is used to adjust the position of the stepper motor manually.