Geomatica II - Module 4: Publishing Map Projects
To change the scale of an Area: 1. In the Maps tree, right-click the Natural area and select Properties. 2. Under the General tab, enter a Scale of 1:8000000. 3. Click OK. The scale of the Natural Area changes in the view area. 4. Repeat steps 1 to 4 for the Built area. Both Areas are now displayed at the same scale. Now you will position both Areas in the view area leaving enough space to add surround elements. To position an Area: 1. In the Maps tree, select the Natural Area. 2. In the Focus view area, position your mouse on the outline of the Area until you see a four-directional arrow. 3. Click and drag the Area to a new position. 4. Repeat steps 1 to 3 for the Built Area.
Tip You can also change the Area position under the Layout tab in the Area Properties window.
Your layout should look similar to the figure below. Figure 4.7 Setting Up Areas in a Map Project
112
PCI Geomatics