3-7 Refitting the engine - 950 Adventure – Before mounting the engine, attach the water, SLS and vacuum hoses (Öttiger clamps - special pliers 600.29.057.000 or springloaded band-type clamps - special pliers 600.29.057.100) – Position the swing arm and fix with the swing arm pivot on the right and a suitable pipe on the left.
– Lift the engine into the frame with the trolley jack, insert the sealing washer in the rear exhaust flange and secure with copper paste if necessary. – Guide the chain along the side of the pinion and insert the swing arm pivot 1, screw on the nut but do not tighten yet. – Insert the bolt 2 in the lower support (raise or lower the engine slightly if necessary). – Remove the trolley jack attachment 600.29.055.100 from the engine.
1 2 3
– Plug the connector on the oil pressure switch 3, the temperature sensor 4 and the front and rear ignition coil 5. Use cable clips to fasten the wiring harnesses.
5
4
– Screw on the ground wire connection 6. – Attach the pulse generator connector 7.
6 7 – Position the foot brake pedal, apply Loctite 243 to the bolt 8 and tighten to 25 Nm.
8