ASK THE EXPERTS RECHARGEasia
roller holders, carefully pry them up from the sides. Clean them with a cotton swab and alcohol. See Figure 50 30) HY cartridges have a seal and set of gears for the additional augers. Remove the seal and clean out any remaining toner. See
Figure 54
Figure 57
and alcohol. See Figure 54 34) Install the cleaned PCR/PCR
Figure 51 Figure 51 31) Remove the 2 screws and the wiper blade. Clean out any toner from the waste
Figure 58 Figure 55 Cleaning roller holders. See Figure 55 35) Install the cleaned PCR cleaning roller.
Figure 52
Figure 59
chamber. See Figure 52 32) Coat the wiper blade with your preferred lubricant and install. Install the Figure 56 See Figure 56 36) Install the cleaned PCR. Place a small
Figure 53 two screws. See Figure 53 33) Clean the PCR holders and PCR cleaning roller holders with a cotton swab
amount of new conductive grease on the black holder side. See Figure 57 37) Install the drum. See Figure 58 38) Install the drum axle from the hub side. See Figure 59 39) Install the E ring. See Figure 60 40) On the toner hopper, install the white auger gear as shown. At this point the remaining gears must also be set properly.
www.rechargeasia.com
Figure 60 If the cartridge is a HY the top 2 gears must point to the arrows on the cartridge as shown. For all cartridges on the lower half, the gears must be pointing to the arrow and gear as shown See Figure 61 41) Install the developer roller drive
RECHARGEasia
• FEBRUARY 2012 • 47