70 20-2
Tractors, 200 Series SM-2 105 (Oct-76)
Miscellaneous Attachments
ADJUSTING ATTACHMENT LIFT 37A Snow Thrower
5. Adjust the clevis on the lift rod until the rod can be reattached to the secondary lift shaft. At this point, turn the clevis onto the rod approximately four complete turns (this wtll allow for slack in the linkage). Move the lift control lever forward and attach the lift rod clevis to the secondary lift shaft.
6. Move the control lever to the rear and check that the arm an snow throwers (Serial No. 30,0011 just touches the stop or the chute clears the hood on snow throwers (Serial No. -30,000),Fig. 3.
43 Front Blade
>,
.Fir:.A. 3-Raisin0 snow
Attach the front blade to the tractor.
lnrower
1. On snow throwers, (Serial No. 30,0011 raise until the stop arm touches the stop on the mounting plate. On snow throwers (Serial No. 30,000) raise until the chute just clears the hood.
2. Block the snow thrower in this position.
Fig. 5-Lift Blade in Transport Posltion
1. Lift the blade to transport position and pin it in this position.
2. Disconnect the rear lift rod clevis at the secondary lift shaft. Pull the lift control lever all the way to the rear. When the tractor is equipped with an electric lift, check that the control switches have reached neutral posit~on.(See 'Checking Electric Lift," page 70-20-1).
Fig. 4-Adjusting Lift Link
3. Turn the clevis on the lift rod until it can be attached, then turn the clevis approximately four complete turns further onto the lift rod, Fig. 4.
3. Disconnect the clevis on the lift rod at the secondary lift shaft.
Move the control lever forward until the lift rod can be attached to the secondary shaft.
4. Pull the !ift lever all the way to the rear (or raised position).
NOTE: (Electriclift equipped tracfors.)When the lift stops, check that the confrolswitches have returned fo neutral posifion b y turning the key switch on and off.I f the lift solenoids click, the switches have not returned to neutral position. Correct by adjusting the stop spacer.
Lifho in U.S.A.
\
4. After attaching the lift rod, pull the lift lever to the rear, then check the following conditions. A. The transport pin can be removed by hand.
6. When tractor is equipped with an electric lift, the control switches must reach a neutral position.